Connecting rod HOT RODS for KAWASAKI KDX, KX 125, 200 1974 to 1993

HOT RODS offers you this complete connecting rod kit for your KAWASAKI KX 125cc and KAWASAKI KDX 200cc. This complete pack will allow you to refurbish your crankshaft which may have some play from top to bottom. Rather than changing the complete crankshaft, you will often just need to change the connecting rod. This connecting rod is a cast model sold with its needle cage, its anti-friction shims and its crank pin. It has the same original dimensions. No adaptation is required. To change a connecting rod, you will need a press, a balancing bench and a little patience. If you don't have the material to do that, you can send us your crankshaft so that we can do the assembly ourselves. You can contact us first by e-mail to get a quote. All the dimensions of the connecting rod are given below.

Technical data :

Big End I.D. connecting rod: 29mm

Width of connecting rod head: 16.900mm

Center to Center Connecting Rod: 106mm

Small end connecting rod I.D.: 21mm

Connecting rod width: 16.900mm

Engine type: 2 stroke

Includes connecting rod, crank, crank bearing, wrist bearing and thrust washers

Spindle diameter: 22mm

Spindle length: 50.900mm

EP washer: 1mm

Fits on :

KAWASAKI KDX 200 (KDX200C) 1987

KAWASAKI KDX 200 (KDX200C) 1986

KAWASAKI KX 125 (KX125A) 1981

KAWASAKI KX 125 (KX125A) 1980

KAWASAKI KX 125 (KX125A) 1979

KAWASAKI KX 125 (KX125A) 1978

KAWASAKI KX 125 (KX125A) 1977

KAWASAKI KX 125 (KX125A) 1976

KAWASAKI KX 125 (KX125A) 1975

KAWASAKI KX 125 (KX125A) 1974

KAWASAKI KX 125 (KX125B) 1983

KAWASAKI KX 125 (KX125B) 1982

KAWASAKI KX 125 (KX125C) 1984

KAWASAKI KX 125 (KX125D) 1985

KAWASAKI KX 125 (KX125E) 1987

KAWASAKI KX 125 (KX125E) 1986

KAWASAKI KX 125 (KX125J) 1993

KAWASAKI KX 125 (KX125J) 1992