Connecting rod HOT RODS for HONDA CR and SUZUKI RM 125 from 1981 to 1986

HOT RODS offers you this complete connecting rod kit for your HODNA CR 125cc and SUZUKI RM 125cc. This complete pack will allow you to refurbish your crankshaft which may have a play from top to bottom. Rather than changing the complete crankshaft, you will often just need to change the connecting rod. This connecting rod is a cast model sold with its needle cage, its anti-friction shims and its crank pin. It has the same original dimensions. No adaptation is required. To change a connecting rod, you will need a press, a balancing bench and a little patience. If you don't have the material to do that, you can send us your crankshaft so that we can do the assembly ourselves. You can contact us first by e-mail to get a quote. All the dimensions of the connecting rod are given below.

Technical data :

Big End I.D. connecting rod: 28mm

Width of connecting rod head: 15.950mm

Center to Center Connecting Rod: 100mm

Small end connecting rod I.D.: 18mm

Connecting rod width: 17.900mm

Engine type: 2 stroke

Includes connecting rod, crank, crank bearing, wrist bearing and thrust washers

Spindle length: 52.900mm

EP washer: 1mm

Fits on :

HONDA CR 125 R (JE01) 1984

HONDA CR 125 R (JE01) 1983

HONDA CR 125 R (JE01) 1982

HONDA CR 125 R (JE01) 1981

SUZUKI RM 125 1986

SUZUKI RM 125 1985

SUZUKI RM 125 1984